Disassembly, maintenance and storage
Open the board’s protective cover and rinse each component with clean water, without disconnecting the cables.
You should also thoroughly rinse the mast and propeller.
Then dry the inside of the board with a dry towel to remove any
moisture.
Ensure that the ESC, battery and the inside of the connector sockets are completely dry.
Disconnect the sensors, and check that there is no water or sand inside.
Remove the battery, dry it completely and store in a dry place.
Once the electrical connector sockets are completely dry, reattach the connectors.
To remove the wing of your foil, unscrew the fuselage screws and put them back in position so you don't lose them.
To remove the mast, unscrew the screws in a criss-cross manner, slide them to the end of the groove, and gently remove the foil without excessive force. Tighten the screws again.
Store your board in a cool, dry place away from direct light.